Wood Chipper Troubleshooting

Low yield

①The blade is not sharp; 

②The blade is not adjusted properly, and the sawdust will not be granular.

Sharpen the blade

Difficulty in feeding

①The blade is worn and not sharp; 

②The gap of the fixed knife is too small or too large

① Sharpen the blade; 

② Adjust the gap of the fixed knife 2– 3mm;

③ The blade angle cannot be greater than 30 degrees

Overload

①The feed is too fast and uneven; 

②The blade is not sharp

①Reduce the feeding speed; 

②Sharpen the blade

Bearing heating

There is no butter in the bearing seat; 

②The bearing seat is not installed flat; 

③The bearing is damaged; 

④The belt is too tight

Add butter to the bearing; 

②Bearing seat balance; 

③Replace the bearing; 

④Adjust the belt tightness.