How to avoid unqualified output size from sawdust making machine

Producing qualified sawdust making machine is the basic goal of every manufacturer, and the qualification rate is also the standard for measuring everything. If the qualification rate of the products produced is low, it will seriously affect the work efficiency. If the qualification rate is low, the repair rate will naturally be high. The cost investment will be higher and the profit will decrease. Therefore, for every user, the discharge qualification rate of the wood crusher is very important. The purpose of operating the wood crusher is to produce qualified finished products. Only the finished products are qualified. , the operation is meaningful, so in daily operation, avoiding unqualified wood crusher discharging is the key to the task. Today we will talk about how to avoid unqualified wood crusher discharging.

       First of all, it is necessary to understand what constitutes unqualified discharging. The material is not fine enough, or not thick enough, the material is too moist, the material contains impurities, etc. These are all cases of unqualified discharging. The specific requirements are determined according to the user's needs.

       After clarifying the qualified standards, produce materials according to this standard. If you produce unqualified materials, you must find the reasons to solve them. Why does this happen? For example, the materials are too wet. It depends on whether the crushed raw materials contain The water volume is too high, or the temperature inside the machine is too high, or the wood crusher is filled with water, etc. After the cause is found out, the corresponding treatment can be carried out.