Any mechanical problems should be checked from the fundamental important parts

As we all know, for all forestry machinery industries, there will be problems in the production of wood crushers. You may feel ridiculous, how can a mechanical equipment have problems? In fact, there are, but here is just a metaphor Said. Looking at the entire Electric Wood Chipper industry, our domestic ones are mainly concentrated in the Central Plains. But customer needs are everywhere. It is difficult for customers to travel all the way to the Central Plains to buy wood crushers, and the market demand for wood crushers has also increased. Therefore, the production problems of the wood crusher should be solved in a timely manner. The cutting tool used in the production of wood shredder equipment, the geometric parameters of the cutting part have a great influence on the cutting efficiency and processing quality. Increasing the rake angle can reduce the plastic deformation when the rake face squeezes the cutting layer, and reduce the frictional resistance of the chips flowing through the front, thereby reducing the cutting force and cutting heat. However, increasing the rake angle will reduce the strength of the cutting edge and reduce the heat dissipation volume of the cutter head. When we choose the angle of the tool when we produce wood shredders, we will consider many factors, such as workpiece material, tool material, processing properties (rough and finishing), etc., which must be selected reasonably according to the specific situation.

What kind of problems will there be when the Sawdust Making Machine  is reproduced? It is nothing more than a small problem during production, which causes the customer to be unable to complete the production when using it, the phenomenon of problems with the wood grinder, and the problem solving of the production of the wood grinder Method. The first thing is that the output becomes low during production. The reason may be that the blade is not sharp. The solution is to sharpen the knife, and then the feeding is difficult. The reason: the blade is worn, and the solution: sharpen the knife, adjust the gap between the blades or the gap is unreasonable. Finally, the load of the wood crusher is too large during production. The solution: adjust the feeding speed. Before the wood shredder produces wood chips, the following steps are required: wood chip washing, wood chip preheating, slurry grinding, slurry screening, purification, concentration, fine grinding and storage. These are the preparatory conditions before production, and there is another link that also has a certain influence, that is, the refining concentration. High temperature, low moisture, and low wood density are easy to soften, so the refining concentration is also high. There are pros and cons to everything. The same is true for the production of wood chips by wood shredders. There are advantages and disadvantages at the same time. The advantages are that the disc mill has a large production capacity, a small footprint, and a high degree of automation.